Shown with fan and light kit (not included) Hunter Accessory Table Installation Instructions 47007-01 11/20/2007
Read all instructions carefully before beginning installation. Save these instructions. CAUTIONS • • • • • • Read entire installation instructions carefully before beginning installation and save these instructions. DO NOT climb on pole or table. Follow the assembly and operation instructions included with the fan. Use ONLY Hunter replacement parts. DO NOT assemble or place this fan on unlevel ground. Install this accessory table ONLY on HunterTM fan models 20523 and 28492.
Your new accessory Hunter table can be installed at one of three heights: bar height standard table height 44.5” (113 cm) lounge height 31.5” (80 cm) 23” (58 cm) *shown with optional accessory light kit (not included) Step 1 Note: Be sure to hold the power cord out of the way of the bolt. Do not allow the power cord to slip down the pole. 1. Insert the bolt into the lower pole section and secure with the cotter pin.
Step 2 2. Attach the upper adapter to the table with six adapter screws with washers. Thread the lower adapter into the upper adapter and rotate one to two turns. Note: The lower adapter should not be over-tightened. It should remain loose in the upper adapter to properly attach to the table. Table Hardware Needed: Adapter Screw 64193-03-247 (x 6) Lower Adapter Upper Adapter Table Hardware Needed: Washer 64187-01-247 (x 6) Step 3-4 Table 3.
Hunter Fan Company 2500 Frisco Avenue Memphis, Tennessee 38114 © 2007 Hunter Fan Company
