Operation Manual

C
B
A
7
MOUNTING THE OUTDOOR CONTROLLER TO WALL .......................................................
NOTE: Outdoor model is water and weather resistant.
Connecting the outdoor EC to the primary power should
only be done by a licensed electrician following all local
codes. Improper installation could result in shock or fire
hazard.
1. Select a location that is conveniently close to a power supply.
2. Make sure to abide by all electrical and installation codes when
attaching to an external wall.
3. Place the controller at eye level and align keyhole (A) on top of the
controller and mark the spot as well as the three holes (B) on the
bottom of the unit.
4. Drill a 6 mm hole at each mark.
5. Install screw anchors (C) into holes if attaching controller to
drywall, masonry, or plaster walls.
6. Holding the controller cabinet, line up the holes in the cabinet with
the wall anchors or pilot holes.
7. Drive a screw through each hole and secure snugly but do not
over tighten.