Quick Start Guide

Built on Innovation
®
5
Important Connections and Tips


CONNECTING AND DISCONNECTING THE FACEPACK
The facepack cable connection is located just below the light
on the Power Supply Board. Turn power to controller o
before connecting or disconnecting the facepack.
SYNCPORT™ CONNECTION
The SyncPort connection is a proprietary Hunter connection
for external interface devices. It is located near the top of the
Power Supply Module.

SyncPort

Facepack Cable Connection
Do not attempt to connect the facepack cable to
this port. The connector has a protective cover
which should be le in place until the connection is
needed.
If power to the controller is le o for extended
periods, the battery will be consumed more quickly.
Consult the connecting device’s manual for additional
instructions regarding SyncPort.
SD CARD READER
The bottom edge of the facepack includes a built-in SD card
reader. The controller is supplied with an SD card.
The SD card can:
• Upload updated rmware, saved from email or the
HunterIndustries.com web site, to the controller and all its
modules.
• Store logs, Easy Retrieve backups, and other information
for use later or on another device. See Advanced Features
menu on page 30.
BATTERY
The ACC2 has a replaceable internal lithium battery in the side
of the facepack, used to backup time settings (only during
power outages). The battery may last the life of the controller,
but is easily replaced if necessary.
Use a standard CR2032 replacement if necessary. Take care to
place the + side of the battery correctly.