Quick Start Guide
12 hunter.direct/ACC2help
Basic Programming and Setup
PUMP/MASTER VALVE SETUP
From Main Menu, dial to the Stations menu. Set Station P/MV
Usage for each station, if necessary.
P/MV outputs 1 through 3 always refer to the output terminals
on the Power Supply Board. P/MV outputs 4, 5, and 6 can be
assigned to regular station outputs. See So P/MVs
on page 12.
All P/MV outputs are set to Normally Closed operation,
but they can be changed to Normally Open functions in the
Devices menu. See P/MV Operation section on page 18.
The ow settings on this screen are not necessary for basic
operations.
SOFT P/MVS 46
P/MV outputs 4 through 6 will show as “Disabled”, unless you
select one of the station outputs to be used as an additional
P/MV.
These are called “so P/MVs”. Once a station is designated as
a P/MV, that is its only function, and it must not be included in
irrigation programs as a “regular” station.