Installation Sheet

ManualsBrandsHunter ManualsCeiling FansUniversal Fan-Light Remote Control - Less Receiver

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

This device complies with RSS-210 of Industry Canada. Operation is subject to

the following two conditions: (1) this device may not cause interference, and (2)

this device must accept any interference, including interference that may cause

undesired operation of the device.

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures: Reorient or relocate the

receiving antenna, Increase the separation between the equipment and receiver,

Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected. Consult the dealer or an experienced radio/TV technician

for help. Note: Any changes or modifications to the transmitter or receiver not

expressly approved by Hunter Fan Company may void one’s authority to operate

this remote control. Chemical burn hazard. Keep batteries away from children.

This remote contains a lithium button cell battery. If a new or used lithium button/

coin cell battery is swallowed or enters the body, it can cause severe internal burns

and can lead to death in as little as 2 hours. Always completely secure the battery

compartment. If the battery compartment does not close securely, stop using the

product, remove the batteries, and keep it away from children. If you think batteries

might have been swallowed or placed inside any part of the body, seek immediate

medical attention. Dispose of cells properly and keep away from children. Even

used cells may cause injury.

Remote Control of Fan is Erratic

• Make sure the battery is installed correctly.

• Install a fresh battery.

Multiple Remote Issues

• If you have multiple remotes or multiple remote-controlled fans

installed on the same circuit breaker and you are experiencing

interference or faulty operation of your remote controls, please go to

www.HunterFan.com/FAQs and click “How do I properly install multiple

remote-controlled fans?” for information on how to correct this issue.

This product conforms to UL Standard 1917.

WARNINGS

CEILING FAN REMOTE CONTROL

Model 99813

HUNTER FAN COMPANY CONTROL LIMITED WARRANTY

The Hunter Fan Company makes the following limited warranty to the original purchaser

of the Control (“Control”): Your Control is warranted to be free from defects in material and

workmanship for a period of one year from the date of sale. If the Control malfunctions or fails

within the warranty period due to a defect in material or workmanship we will replace it free

of charge. IF THE ORIGINAL PURCHASER CEASES TO OWN THE CONTROL, THIS WARRANTY

AND ANY IMPLIED WARRANTY, INCLUDING BUT NOT LIMITED TO ANY IMPLIED WARRANTY OF

MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE VOIDED. THIS WARRANTY

IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES. THE DURATION OF ANY IMPLIED WARRANTY,

INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS

FOR A PARTICULAR PURPOSE, IN RESPECT TO ANY CONTROL, IS EXPRESSLY LIMITED TO THE

PERIOD OF THE EXPRESS WARRANTY SET FORTH ABOVE FOR SUCH CONTROL. This warranty

excludes malfunctions or failures which were caused by repairs by persons not authorized by

us, mishandling, improper installation, modications, or damage to the Control while in your

possession, or unreasonable use. This warranty does not apply to batteries or to deterioration

or damage to the product caused by the use of faulty batteries. To obtain a replacement, return

your Control postage prepaid along with proof of purchase to Hunter Fan Company Service

Department at 7130 Goodlett Farms Pkwy., Memphis, TN 38016. IN NO EVENT SHALL HUNTER

FAN COMPANY BE LIABLE FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES. SOME STATES DO

NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR THE EXCLUSION

OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES SO THE ABOVE LIMITATIONS

OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS

AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE.

Installing the battery

Pair the remote with a

compatiable receiver.

Before installation, use the pull chains to set the

fan speed to HIGH and the light to ON. Ensure

the power is OFF at the outlet box and wall switch

location before proceeding with installation.

Turn Power

OFF

Option 1

Option 2

Turning off the power

Using screws

Using Adhesive Strip

To access the battery compartment,

remove the small Phillips head

screw that secures the battery door

to the remote control.

Replace the used battery with a

CR2032 battery when necessary. The

battery should be installed with the

positive (+) side up.

Phillips

Head

Screw

Battery

Door

Turning on the power

If you are installing multiple remote-controlled fans

on the same circuit breaker,

you may need to perform a few extra steps to prevent interference or faulty operation of

your remote controls.

Go to www.HunterFan.com/FAQs and click “How do I properly install multiple remote-

controlled fans?” for more information.

Turn Power

IMPORTANT

Install the cradle bracket to the wall with the

included screws.

You have two options to install the included remote control cradle

to the wall. Choose which path works best for you.

Choose your cradle installation location.

If you are installing into drywall, drill two 9/64

width holes using the cradle bracket as a guide.

Gently hammer the included drywall anchors into

the pre-drilled holes.

Press the cradle bracket against the wall and

hold rmly for 30 seconds.

Apply the adhesive sticker to the back of cradle bracket

per the instructions on the adhesive sticker.

Slide the cradle onto the mounted bracket.

Remove the cradle from the

cradle bracket.

Note: To pair your remote, remove the battery

door. Cycle power to the fan by turning power off

and back on at the wall switch (or circuit breaker

if necessary). Within three minutes, press the pair

button on the remote.

To prevent faulty operation, please

disconnect power from all other ceiling fans

within range while pairing.

WARNING

To avoid possible electrical shock, before

installing your fan, disconnect the power by

turning off the circuit breakers to the outlet box

associated with the wall switch location.

The Hunter Handheld Control requires an installed

compatible receiver to function. Please follow the

installation instructions included with the receiver prior to

setting up your Handheld Control.

Installation

Read and Save These Instructions

Remote Cradle Remote Functions

Troubleshooting

Key Press Function

Light On/Off+ Quick Press

Light Dimming+ Long Press

Fan On/Off+ Quick Press

Fan Reverse

(For fans without a reverse switch ONLY)

+ Long Press

Raise Fan Speed+ Quick Press

Fan HighLong Press

Lower Fan Speed+ Quick Press

Fan LowLong Press

Dimming Mode On/Off

Long Press

Fan Downdraft

(For fans without a reverse switch ONLY)

Long Press

Fan Updraft

(For fans without a reverse switch ONLY)

Long Press