Warranty

4" Personal Retro USB Fan4" Personal Retro USB Fan
Model
Operating Instructions:
Care and Maintenance Instructions:
Fan Parts:
WARNING:
• Always unplug from electrical supply source before
cleaning.
• Do not allow water to drip on or into the fan motor
housing.
• Be sure to use a soft cloth moistened with mild soap
solution. Do not use harmful cleaners.
• After servicing, all safety devices (including grills and
blades) must be reinstalled or remounted as
previously installed.
A. Fan Grill
B. Switch
C. USB Cable
61807-01
90507
90508
90509
90510
20200320
A
B
C
READ AND SAVE THESE INSTRUCTIONS!
WARNING: To reduce the risk of re or electric shock, do
not use this fan with any solid-state speed control device.
RULES FOR SAFE OPERATION:
• Use this fan only for purposes described in this manual.
• This fan is intended for household use only and not for
outdoor, commercial and industrial use.
• This fan is not intended for use in kitchens.
• To protect against electric shock, do not place fan in a
window, immerse unit or cord in water or spray with
liquids.
• Close supervision is necessary when any appliance is used
by or near children.
• Do not insert ngers or any objects through the grill guard
when fan is in operation.
• Do not operate this unit without fan guards properly locked.
• Avoid contact with moving parts.
• Do not operate in the presence of explosive and/or
ammable fumes.
• Do not place fan or any parts near an open ame, cooking
or other heating appliance.
• Do not hang or mount fan on a wall or ceiling.
• Do not let the cord hang over the edge of a table, counter
or come into contact with hot surfaces.
• Do not run cord under carpeting. Do not cover cord with
throw rugs, runners, or similar coverings. Do not route
cord under furniture or appliances. Arrange cord away
from trafc area and where it will not be tripped over.
• Do not operate fan after a malfunction or has been
dropped/damaged in any manner.
• Always use on a dry, level surface.
1. Set the Fan Base on a dry, level surface.
2. USING USB DC SUPPLY: Make sure the On/Off
Switch located at the side of the fan is at the left (Off)
position. Insert the low voltage output plug of
converter to the fan input jack at the back of the fan.
Plug the USB cord into any standard USB port, such
as the USB output jack from a PC.
Warning: Only use DC 5V power.
3. Now switch the fan to the “on” position by sliding the
Switch to the right.