Installation Guide

6
New construction attaching to joist
Screw pre-loaded screws into joist or framing.
Connect 4” duct and vent to the outside. Tape joints.
If ducting does not fit securely, an adapter may need
to be purchased.
Position the correct depth mark at the bottom edge of
the joist based on the thickness of your sheetrock.
Pull wires through the strain relief.
Install the wiring cover plate. Make sure all wiring connections
are inside the box or under the wiring cover plate.
5/8
1/2
A11
A12
A13
F1
A14
A15
0
A16
48050-01 - R20151220
Go to step F1 on page 18 to connect the wires as shown.
E