Installation Guide

8
1886
1886
Feed the wire plug through the center hole
of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
Repeat x3
Installing the Glass
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Assembling the Light Kit
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 3 1 of 3
Housing Assembly
Screw
Housing Assembly
Screw
bag bag
1 of 3
bag
Lower Switch
Housing Screw
2 of 3
Lower Switch
Housing Screw
bag
1
STEP
4
STEP
2
STEP
5
STEP
3
STEP
6
STEP
Screw two housing assembly screws from the
hardware bag halfway into the motor housing. It does not
matter which two screw holes you choose.
Connect the plugs from the upper and lower
switch housings. Make sure to line up the
colored markings on the connectors.Wrap light
kit keyhole slots around the screws and twist
counterclockwise.
Install a bulb into each of the sockets.
When necessary, replace with bulbs of the
same type and wattage.
Loosen the thumbscrews. Insert the
globe into the xture and retighten the
thumbscrews securely. Do not overtighten.
Screw two lower switch housing assembly
screws from the hardware bag halfway into
the upper switch housing. It does not matter
which two screw holes you choose.
Insert the third screw, found in the
hardware bag, into place and then tighten all
three screws.
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Glass Remote CradleRemote
Insert the third screw, found in the
hardware bag, into place and then tighten
all three screws.
Fan style may vary.
Note:
Fan style may vary.
Note: