Instructions / Assembly

8
1886
Canopy Screw
Note: The screw was installed for shipping purposes only.
Preparing the Light Fixture
Installing the Light Fixture Hood
Ceiling Bracket Housing Downrod Hanging Fan Wiring BladesCanopy Light FixtureHood Pull Chains Glass/Cage
Repeat x2
Remove the pre-installed xture screw and red
ag from the light kit assembly. Save the screw.
It will be needed for light kit installation.
Loosen the other three xture screws, but do
NOT remove completely.
Follow these steps to prepare the light xture for installation.
KEEP
Fixture Screw
Remove and discard the
plastic connectors from the
ends of the two pull chains.
Carefully remove the light xture
from the light xture hood and
set the light xture aside.
Insert the third screw, found in the hardware
bag into place and then tighten all three screws.
1 of 6
Fixture Mounting Screw
bag
Blade Arm Screw
WARNING
FAN FALL HAZARD
Make sure screws are tight to secure the upper
switch housing to the mounting plate.
Red Flag
Partially install two xture mounting
screws ,found in the hardware
bag, into the motor housing as
shown. It does not matter which two
screw holes you choose.
Feed the wire plug through the center hole of the light
xture hood. Align the keyhole slots in the hood with
the two screws you just installed. Lift the hood so that
the keyhole slots engage the two screws, and twist
counterclockwise to lock the hood into place.
2 of 6
Fixture Mounting Screw
bag