Instructions / Assembly

5
1886
1886
Wiring the Fan
Ceiling Bracket DownrodBlade Irons Hanging Fan Wiring Canopy Blades Light Bulbs/Glass Remote CradleRemote
Hanging the Fan
S
l
i
d
e
c
a
n
o
p
y
o
v
e
r
d
o
w
n
r
o
d
a
n
d
w
i
r
e
s
.
Place the downrod ball into
the slot in the ceiling bracket.
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
Installing the Downrod
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
2
STEP
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.
3
STEP
Lower the adapter cover until it rests ush
against the motor housing.
Pass all wires to one side of horizontal
bar in downrod assembly. Hand tighten
the downrod (at least 4–5 full turns)
until it stops. Trim the wires coming
from the fan so that 8-inches remain
coming from the top of the downrod.
1
Hunter Pro Tip:
The ground wire attached to the
downrod is approximately 8 inches.
STEP
Slide the adapter cover onto
the downrod until it rests
against the hanger ball.