Installation Guide

www.HunterFan.com
1.888.830.1326
6
M3510-01 • 01/10/13 • © Hunter Fan Company
Hanging the Fan
While holding the wires out of the way, lift
the motor assembly and place the square
hanger into the opening in the ceiling
bracket. Be sure the ground wire attached
to the hanger faces out of the large
opening in the ceiling bracket.
Ground
Wire
Note: Fan style may vary.
Screw
Hole
Locking
Screw
Screw
Hole
Once the motor is in the ceiling bracket,
use the two locking screws, found in the
hardware bag, to secure the motor to
the ceiling bracket. Then partially install
two of the canopy screws, found in
the hardware bag, in the screw holes
on opposite ends of the hanger bracket.