Installation Guide

8
1886
Assembling the LIght Kit
Remove the tape from the pull chains from
the upper switch housing. Feed the wire plug
through the center hole of the upper switch
housing, then wrap the keyhole slots around
the screws and twist counterclockwise.
Partially install two light kit
assembly screws, found in the
hardware bag, halfway into
the motor housing as shown.
It does not matter which two
screw holes you choose.
2 of 3
Light Kit Screw
BAG
1 of 3
Light Kit Screw
BAG
2 of 2
2 of 2
Short Light Kit
Screw
Thumbscrews
BAG
BAG
Insert the third screw found in the ( )
hardware bag, and rmly tighten all three
screws. Connect the plugs from the fan and
upper switch housing. Make sure to line up
the colored markings on the connectors and
that the connectors latch.
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the hardware bag.
Lift glass and align the two exposed glass assembly
holes with two holes in the upper switch housing.
Attach with thumbscrews found in the hardware bag.
Tighten all four thumbscrews.
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs Remote
ON
Turn Power
Install the included bulbs into the
sockets. When necessary, replace
with bulbs of same wattage.
NOTE: Check to ensure
proper engagement.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Fan style may vary.
Note:
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the trim ring to the mounting plate.