Installation Guide

9
1886
Reversing the Fan
Reverse
Switch
Ceiling fans work in two directions: downdraft and updraft.
To change the direction of air ow, turn the fan off and let
it come to a complete stop. The reversing switch is located
inside the light xture. It can only be accessed when the glass
is removed. Slide the reversing switch to the opposite position.
Restart the fan.
Updraft (clockwise rotation)
creates a more indirect airow.
Updraft airow is great for
moving warm air downward.
Downdraft (counterclockwise
rotation) creates a direct breeze
and maximum cooling effect.
Fan style may vary.
Note:
Preparing the Remote
For your convenience, a remote function card
is packed in with your remote.
Install two AAA batteries, found in the remote control
hardware bag, into the transmitter. Clean the battery
contacts prior to installing the batteries. Please contact
your local battery recycling center for proper battery
disposal information.
To access the battery compartment,
remove the the battery door to the
transmitter assembly.
IMPORTANT
• Always purchase the
correct size and grade of
battery most suitable for
the intended use.
• Replace all batteries of a
set at the same time.
• Clean the battery contacts
and also those of the
device prior to battery
installation.
• Ensure the batteries are
installed correctly with
regard to polarity (+ and -).
• Remove batteries from
equipment which is not to
be used for an extended
period of time.
• Remove used batteries
promptly.
ON
Turn Power
The Fan On/Off button turns
the fan on or off. Adjust the
fan speed using the “Fan
Speed Up” or “Fan Speed
Down” directional buttons.
Quickly press the Light button to turn
the lights off and on. Hold the Light
button to raise and dim the light level.
Fan Speed Up
Fan Speed
Down
Fan On/Off
Quick Press:
Light On/Off
Long Press:
Light Dimming
NOTICE
To enable dimming, your remote must be set to
Dimming Mode. To toggle Dimming Mode on or off,
long press the “Fan Speed Up” button and “Fan
Speed Down” button.
: DIMMING MODE
The remote transmitter is already
paired to the receiver and ready to use.
Dimming mode is on by default.
Note: If you need to pair your remote,
turn fan power off and back on at the
wall switch. Within 3 minutes, press
and release the “PAIR” button on the
back of the remote. Do not hold down
the button. To prevent faulty operation,
please ensure all other ceiling fans
within range are turned off at the wall
switch while pairing.
Battery
Door
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs Remote