Specification

7
8
1886
1886
Installing the Bulbs and Glass
ON
Turn Power
Install the included bulb
into the socket. When
necessary, replace with
bulb of same wattage.
Connect the plugs from the upper and
lower switch housings. Make sure to line
up the colored markings on the connectors.
Lift the lower switch housing up until its
screw holes are aligned with the screw
holes in the upper switch housing.
Install the three switch housing screws
found in the hardware bag.
x3
Switch Housing
Screw
bag
4
STEP
5
STEP
6
STEP
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Assembling the Light
Align the screw holes in the switch housing
gasket and the motor housing. Screw two
mounting screws from the hardware bag
halfway into the motor housing. It does not
matter which two screw holes you choose.
Feed the wire plug through the center
hole of the upper switch housing,
then wrap keyhole slots around the
screws and twist counterclockwise.
Insert the third screw, found in
the hardware bag, into place
and then tighten all three screws.
2 of 3
1 of 3
Mounting Screw
Mounting Screw
bag
bag
1
STEP
2
STEP
3
STEP
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the upper switch housing to the mounting plate.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure the
lower switch housing to the upper switch housing
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Glass/Bulbs
Lift the glass and attach it
to the light xture using the
three thumbscrews. Tighten
all three screws securely by
hand.
Want to install your fan without a light kit?
Go to www.HunterFan.com/FAQs and click “How do I install my
fan without the light kit?”
Hunter Pro Tip: