Specification

ManualsBrandsHunter ManualsCeiling FansIrvine 52 in. Indoor Matte Black Ceiling Fan with Remote and Light Kit

1886

Installing the Canopy

2 of 3

Canopy

Screws

bag

1 of 3

Canopy

Screws

bag

Swing the fan up to align the

canopy screw holes with the

mounting holes on the ceiling plate.

Hold the canopy up with the screw holes

aligned. Partially install two canopy screws,

found in the hardware bag, into the

holes opposite the ceiling plate hooks.

Partially install a canopy screw, found

in the hardware bag, between

the ceiling plate hooks. When all the

holes are properly aligned, securely

tighten all three canopy screws.

Note: The slots in

the canopy must

remain engaged while

swinging the canopy

for alignment.

Place the receiver inside the

canopy. Ensure the wires

remain connected.

WARNING

FAN FALL HAZARD

Make sure screws are tight.

Ceiling Plate Hooks

Ceiling Bracket Hanging Fan Wiring Canopy Blades Light Bulbs Remote

Fan style may vary.

Note:

Fan style may vary.

Note:

Installing the Blades

Repeat x5

x15

bag

Blade Screw

x15

bag

Blade Washer

Put the blade washers found in the hardware

bag onto the blade screws found in the

hardware bag. Then install the blade screws to

secure each blade to the fan.

IMPORTANT

NOTE: Follow the instructions on the blade. Installing it

incorrectly could result in your fan not functioning.

We know wiring is hard. Let’s make it easier.

You are going to need these:

4 Wire Nuts (these are in the

bag)

Follow these steps to get your fan wired quickly and safely. Follow the route below that best matches your wall switch

setup. If you are unfamiliar with wiring or uncomfortable doing it yourself, please contact a quali ed electrician.

Wiring the Fan

Hunter Pro Tip:

Here is how to connect the wires:

Push the bare metal ends of the wires together and slide a wire

nut over them. Then, twist the wire nut clockwise until tight.

Give it a gentle pull to make sure none of the wires are loose.

Connect the 2 grounding

wires (green, green/

yellow stripe, or bare

copper) coming from the

ceiling and ceiling plate.

Connect the black wire

(ungrounded) from the

ceiling to the black

wire from the receiver.

Connect the white wire

(grounded) from the ceiling

to both the white wire from

the receiver and the white

wire from the fan.

White

Black

Ungrounded

Grounded

Connect the blue wire

from the receiver to the

blue wire (or possibly

black with white stripe

wire) from the fan.

Connect the

yellow wire from

the receiver to

the black wire

from the fan.

Black

Yellow

Blue

WARNING

All wiring must be in accordance with

national and local electrical codes ANSI/NFPA

70. If you are unfamiliar with wiring or in

doubt, consult a quali ed electrician.

STEP

WARNING

The ceiling fan must be grounded. If the

ground wire for the installation site is not

present, immediately STOP installation and

consult a quali ed electrician.

Have extra wiring?

Turn the wires upward and push them

carefully back through the hanger bracket

into the outlet box. Spread the wires apart,

with the grounded wires on one side of the

outlet box and the ungrounded wires on the

other side of the outlet box. Make sure that

the wires are still attached to the wire nuts.

Hunter Pro Tip:

LPSMKSTK19-01 r092421

Fan style may vary.

Note:

bag