Installation Guide

7
8
1886
1886
Installing the Bulbs and Glass
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Glass Remote CradleRemote
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one quarter of a
full turn of the glass until it stops.
Blade Arm Screw
Blade Screw
Assembling the Trim Ring
Assembling the Light Fixture
Notch
Tab
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the trim ring to the mounting plate.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the light xture to the trim ring.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Blade Grommet
Feed the 9-pin wire plug through the center
hole of the upper switch housing, then wrap
keyhole slots around the screws and twist
counterclockwise.
Connect the plugs from the upper and lower
switch housings. Make sure to line up the colored
markings on the connectors. Lift the light xture so
that the larger keyhole slots slide over the screws.
Rotate the light xture counterclockwise. Ensure all
three screws are engaged in the keyhole slots.
After rotating the light xture into place, tighten all
three screws securely.
After rotating the light xture into place,
tighten all three screws securely.