Installation Guide

7
8
1886
1886
Installing the Blades:
Repeat x5
Installing the Bulbs and Glass
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Glass Remote CradleRemote
Lightly attach the blade irons to the motor with screws found in
the hardware bag, then securely tighten after both screws are
attached. Repeat this step for each blade assembly.
Repeat x5
x10
x15
x15
bag
bag
bag
Blade Arm Screw
Blade Screw
Assembling the Trim Ring
Installing the Canopy
x2
Lift the canopy into place so that
the screw holes are aligned.
Insert the two canopy screws
found in the hardware bag.
F
i
t
t
h
e
c
a
n
o
p
y
i
n
p
l
a
c
e
a
s
s
h
o
w
n
.
bag
Canopy Screw
Install the blade grommets, found in the hardware bag, in the blades by hand. Place each
blade between a blade iron and medallion. Install three blade screws, found in the hardware
bag, to attach the medallion to the blade iron. Repeat this step for each blade.
Blade Grommet
IMPORTANT
NOTE: Follow the instructions on the blade. Installing it
incorrectly could result in your fan not functioning.