Installation Sheet

7
8
1886
1886
Blade Arm Screw
Installing the Bulbs and Glass
ON
Turn Power
Install the included bulbs
into the sockets. When
necessary, replace with
bulbs of same wattage.
Lift the globe and align the notches in
the globe with the tabs in the light kit.
Notch
Tab
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one third of a
full turn of the glass until it stops.
Ceiling Bracket Hanging Fan Wiring Canopy Blades Light Glass/Bulbs Remote
Assembling the LIght Kit
Feed the 9-pin plug connector coming
from the bottom of the motor housing
through the center hole in the light kit
assembly. Connect it to the plug connector
found in the switch housing area of the
light kit assembly. Make sure to line up
the colored markings on the connectors.
WARNING
FAN FALL HAZARD
Make sure all screws are tight to secure
the light xture.
2 of 2
Short Light Kit
Screw
bag
Carefully push all switch housing components
into the switch housing, then install the switch
housing plate using two short light kit assembly
screws, found in the hardware bag.
Fan style may vary.
Note:
Align the keyhole slots in the top of the light kit
assembly with the partially installed screws.
Wrap the keyhole slots around the screws and
twist counterclockwise.
Remove a pre-installed assembly
screw. It does not matter which
screw you choose.
1 of 1
Assembly Screw
1 of 1
Insert the saved assembly screw. Firmly tighten all
the three screws.
Assembly Screw