Specification

7
8
1886
1886
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Remote Troubleshooting
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.
Installing the Bulbs and Glass
Install a bulb into each
of the sockets. When
necessary, replace with
bulbs of same wattage.
Press the globe ush against the metal plate.
With other hand, press the globe keeper over
the threaded rod until it cups the glass and
immediately install the nial cap and screw
the nial onto the threaded rod.
Repeat x3
Assembling the Light
Some components not shown for visual clarity.
Hold the fan body stationary and rotate
the light xture clockwise to engage the
locking pin.
Notch
IMPORTANT
Push the connector and
excess wire into the hole at
the top of the light xture.
The connector and excess wiring
must be pushed into the light
xture in order to successfully
mount the light xture to the fan.
Pin
Raise the light kit to the bottom of the fan.
Align the notch on the mounting ring on the
top of the light kit with the pin in the mounting
bracket on the bottom of the fan.
Connect the plugs from the fan and light xture.
Make sure to line up the colored markings on
the connectors.
Remove the cardboard plug
guard before proceeding!
HOLD HERE
Repeat x5
WARNING
FAN FALL HAZARD
Make sure to secure the light xture.
Metal
Plate
Globe
Globe
Keeper
Finial Cap
Finial