M Model 47110A
® Congratulations! Your new Hunter thermostat will provide years of reliable service. By saving energy, your thermostat will pay for itself during its first season of use. Thank you for buying a Hunter product! Please read this manual for complete instructions on installing and operating your thermostat. If you require further assistance, call Hunter Technical Support at 1-866-268-1936 from 8am to 5pm Central Time. Before starting, remove the mylar label from the LCD display.
® ■ Position wallplate on wall and pull existing wires through large opening. Then level for appearance. Mark holes for plastic anchors provided, if your existing holes do not line up with those on the Hunter wallplate. Wire Labeling (Continued) ■ After labeling wires, disconnect them from the existing thermostat terminals. ■ Remove existing wallplate. To make sure wires do not fall back into wall opening, you may want to tape them to the wall.
® ■ Auto Recovery selector (DISABLE/ENABLE) Wiring Diagrams Your thermostat is set from the factory with the Auto Recovery Feature enabled, which complies with the EPA ENERGY STAR® Program. If you prefer to use normal recovery, slide the switch to the DISABLE position.
® Setting Day and Time (Continued) Revising Programs STEP 3: ■ Familiarize yourself with manually changing programs, so that you can easily modify the programs as your comfort needs change. Follow the steps below to change the program times and temperatures. day/time ■ Press again to change from minute setting to day setting. The current day will be flashing. M NOTE: 1) The program time can be set in 10-minute increments. 2) The program temperature can be set in increments of 1˚C (1˚F).
® System Selector Switch The System Selector switch on the front of the thermostat determines the operating mode of the thermostat. You may select COOL, OFF, HEAT. NOTE: Anytime you install or remove the thermostat from the wallplate, slide the System Selector to the OFF position to prevent the possibility of a rapid system On-Off. Filter Change Indicator system heat off Your thermostat measures the number of hours your heating and cooling system has been in use.
® Auto Recovery TROUBLESHOOTING Hunter’s Auto Recovery feature meets the ENERGY STAR® guidelines for energy efficiency by allowing the heating or cooling system to recover gradually from an energy-saving setpoint temperature to a comfort setpoint temperature. Auto Recovery calculates how early to turn your system back On, so that the room temperature is already comfortable by the start of the comfort temperature program period. Auto Recovery works in both Heat and Cool modes.
