Instructions / Assembly

7
42845-01•01/23/08•HunterFanCompany
4-1. Lift the motor assembly and hook the three tabs over the handles,
one at a time.
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Wall switches are not included. Select an acceptable general-use switch
in accordance with national and local electrical codes.
4-2. Before attempting installation, make sure the power is still off.
4-3. Toconnectthewires,holdthebaremetalleadstogetherandplace
a wire nut over them, then twist clockwise until tight. For all these
connections use the wire nuts provided.
4-4. Connect the bare or green ground wire (grounded) from the
ceiling to the green ground wire (grounded) from the ceiling plate
and the green ground wire from the fan.
4-5. Connect the white wire (ungrounded) from the ceiling to the
white wire (ungrounded) from the fan.
4-6. Connect the remaining wires as follows:
Dual Switch Wiring:
•eblackwire(ungrounded)fromtheceilingtotheblackwire
(ungrounded) from the fan
•eblack/whitewire(ungrounded)fromthefantothewire
(ungrounded) for the wall switch
Single Switch Wiring:
•eblackwire(ungrounded)fromtheceilingtotheblack
(ungrounded) and the black/white wire (ungrounded) from
the fan
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
4-7. Turn the splices upward and push them carefully back through the
ceiling plate into the outlet box.
4-8. Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of the
outlet box.
Dual Switch Wiring
Single Switch Wiring
Wire Nut
Step 3-1
Step 3-6 (Dual)
Step 3-6 (Single)
Handle
Tab
HunterFanCompany 42826-01•3/10/07
4 • Hanging and Wiring the Fan