Instructions / Assembly

5
42845-01•01/23/08•HunterFanCompany
Steps 2-4 – 2-6
CAUTION: To avoid possible electrical shock, before installing your fan,
disconnect the power by turning off the circuit breakers to the outlet box
and associated wall switch location. If you cannot lock the circuit breakers
in the off position, securely fasten a prominent warning device, such as a
tag, to the service panel.
2-1. Drill two pilot holes into the wood support structure through the
outermostholesintheoutletbox.epilotholesshouldbe9/64”
in diameter.
2-2. read the lead wires from the outlet box down through the hole
in the middle of the ceiling plate.
2-3. Aligntheslottedholesintheceilingplatewiththepilotholesyou
drilled in the wood support structure.
2-4. Placeaatwasheroneachofthetwo3”woodscrewsandpass
the screws through the slotted holes in the ceiling plate into the
pilot holes you drilled.
  Tightenthescrewsintothe9/64”pilotholes;donotuselubricants
on the screws. Do not over tighten.
Ceiling
Plate
Flat Washer
3”WoodScrew
2 • Installing the Hanger Bracket