0” Opal Schoolhouse Globe Light Kit Installation Instructions 43506-01 r032907
IMPORTANT: Read all warnings before you begin. • • • • • • CAUTIONS Read entire installation instructions carefully before beginning installation and save these instructions. To avoid possible risk of electrical shock and fire, install this light fixture only on Hunter ceiling fan Type A-Z. Find the fan model number on the fan package or on the nameplate on top of the motor housing.
Removable Switch Housing Installing the Light Kit on Fans with Removable Switch Housings I O 1. Unscrew the three screws from the upper switch housing. Disconnect the 9-pin plug connectors. Remove the lower switch housing. 2. Push the plug button from inside the lower switch housing to remove the plug button and switch housing cap. Unscrew the two attachment screws on the bottom of the switch housing.
Non-Removable Switch Housing Installing the Light Kit on Fans with Non-Removable Switch Housing I O 1. Uninstall the two screws from the switch housing cover. 2. Remove the plug or screw from the center of the switch housing cover. 3. Thread the switch housing cover onto the wires from the light kit. Align the large ends of the keyholes in the light kit with the screw holes in the switch housing cover. Install the nut and washer onto the threaded rod from the light kit to secure the switch housing cover.
Hunter original and nonremovable switch, no center hole Installing the Light Kit on Fans With Non-Removable Switch Housing I O and No Center Hole 1. Uninstall the two screws from the switch housing. 2. Remove the wire nuts from the two wires in the switch housing labeled “Connect Light Here” or “For Light Use.” One wire is white and the other wire is black/white striped. Connect the black/white striped wire from the switch housing to the black wire from the light kit.
Installing the Bulbs, Chains, and Globe 1. Install one 19-watt compact fluorescent light bulb (included) into the socket. 2. Loosen the three thumb screws in the light kit. Raise the glass globe to the light fixture, fitting the rim into the louvered edge. Ensure that the top edge of the globe clears the screws. Hand tighten the thumb screws. 3. Attach the provided breakaway connector onto the end of the pull chain. 4. The installation is complete and you can restore power to the ceiling fan.
