SINCE 1886 R USE AND CARE GUIDE BOWLES 3 LIGHT PENDANT-#M99263
TOOLS REQUIRED Safety goggles Phillips screwdriver Flathead screwdriver Wire strippers Wire cutters Ladder Pliers Electrical tape NOTE: This item requires the use of three 120V, 60Hz, 60-Watt antique bulbs (included) or three 120V, 60Hz, 60-Watt max, medium-base type A bulbs (not included). Do not exceed the recommended wattage. HARDWARE INCLUDED NOTE: Hardware not shown to actual size.
Assembly instructions Installation instructions 1. Assembling the fixture body 1. Installing the mounting plate □ Carefully unpack the fixture, lay out all parts on clean surface. □ Feed the fixture body (E) wires up through the cap (D), 12 inches tubes (C) and then the 6 inches tube (B). The number of tubes you use depends on the length you desire for the installed light fixture, remove the nipple from tube if needed. □ Slide the cap (D) over nipple to top teh fixture body (E).
Installation instructions (continued) 2. Connecting the wires 3. Hanging the fixture and □ Install the fixture bare copper wire (1) under the ground screw (EE) on the mounting plate (BB). □ Connect the fixture bare copper wire (1) to the green (or bare, or green & yellow) supply ground wire (2) in the outlet box using a wire nut (AA). □ Connect the white fixture wire (3) to the white (or ribbed) supply wire (4) in the outlet box using a wire nut (AA).
