SINCE 1886 R USE AND CARE GUIDE CORY 3 LIGHT ISLAND LIGHT -#M99222
TOOLS REQUIRED Phillips screwdriver Wire strippers Flathead screwdriver Electrical tape Wire cutters Ladder Adjustable wrench NOTE: This item requires the use of three 120V, 60Hz, 60-Watt antique bulbs (included) or three 120V, 60Hz, 60-Watt max, medium-base type A bulbs (not included). Do not exceed the recommended wattage. HARDWARE INCLUDED NOTE: Hardware not shown to actual size.
Assembly instructions 1. Assembling the fixture body □ Carefully unpack the fixture, lay out all parts on clean surface. □ Determine how many extension tubes you would like to use. The numbers of tubes you use depends on the length you desire for the installed fixture body. □ Feed the fixture wires up through the 12" tubes (G), the 6" tubes (F). □ Attach the desired number of tubes (F and G) to the fixture body (H) by screwing the tubes in a clockwise direction. Installation instructions 1.
Installation instructions (continued) 2. Connecting the wires 3. Installing the fixture and bulbs □ Install the fixture bare copper wire (1) under the ground screw (EE) on the cross bar assembly (BB). □ Push all excess wires into the outlet box. □ Connect the fixture bare copper wire (1) to the green (or bare, or green & yellow) supply ground wire (2) in the outlet box using a wire nut (AA).
