RION 6 LIGHT CHANDELIER Care and Instruction Manual
Table of Contents Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Planning Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Tools Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Hardware Included. . . . . . . . . . . . .
Pre-Installation PLANNING INSTALLATION Read all instructions before assembly. To avoid damaging this product, assemble it on a soft, non-abrasive surface such as carpet or cardboard. Inspect each part for defects that may have occurred during shipping. Keep your receipt and these instructions for proof of purchase. NOTE: This light fixture requires the use of six 120V, 60HZ, 60-Watt max., candelabra-base type B bulbs (not included). Do not exceed the recommended wattage.
Pre-Installation (continued) PACKAGE CONTENTS = A B D C E Part F Description Quantity A Upper metal frame 1 B Lower metal frame 1 C Narrower glass panel 6 D Wider glass panel 6 E Rubber washer 48 F Finial 24 4
Assembly 1 3 Unpacking the light fixture □ Carefully unpack the fixture, lay out all parts on clean surface. Placing the upper metal frame □ Place the bars of upper metal frame (A) into the slots of styrofoam supporter. NOTE: Make sure the clips on upper metal frame (A) are aligned with the clips on the lower metal frame (B). 2 4 Placing the lower metal frame □ Place the lower metal frame (B) on a flat and soft surface.
Assembly (continued) 5 Assembling the narrower glass 6 Assembling the finials □ Slide the narrower glass panels (C) over the nipples on upper metal frame (A) and lower metal frame (B). 7 Assembling the rubber washers 8 Assembling the wider glass □ Slide the rubber washers (E) over the nipples on upper metal frame (A) and lower metal frame (B). □ Slide the rubber washers (E) over end of the nipples and secure with finials (F).
Assembly (continued) Installation 9 1 Assembling the finials □ Slide the rubber washers (E) over end of the nipples and secure with finials (F). Installing the cross bar CAUTION: Ensure the power is off at the main fuse box prior to beginning installation. □ Turn off the switch at the wall. □ Turn the power off at the main fuse box. □ Install the cross bar (BB) with nipple (FF), lock nut (DD), and screw collar loop (HH) to the outlet box using two outlet box screws (CC).
Installation (continued) 2 4 Connecting the wires □ Wrap the bare copper or silver ground wire (1) from the fixture around the ground screw (EE) on the cross bar (BB) and connect it to the supply ground wire (2) from the outlet box using a wire nut (AA). Assembling the bulbs CAUTION: Ensure the power is off at the main fuse box prior to beginning installation. □ Prior to installing the bulbs, please inspect sockets for silica packet. if packet is present, remove and throw away.
