SINCE 1886 R USE AND CARE GUIDE CORY 1 LIGHT OUTDOOR WALL LANTERN-#M00066
TOOLS REQUIRED Safety goggles Phillips screwdriver Flathead screwdriver Wire strippers Wire cutters Ladder Pliers Electrical tape NOTE: This item requires the use of one 120V, 60Hz, 60-Watt antique bulb (included) or one 120V, 60Hz, 60-Watt max, medium-base type A bulb (not included). Do not exceed the recommended wattage. HARDWARE INCLUDED NOTE: Hardware not shown to actual size.
Pre-Installation (continued) PACKAGE CONTENTS D C B A Part Description Quantity A Antique bulb 1 B Socket ring 1 C Glass shade 1 D Fixture body 1 3
Installation instructions 1. Installing the mounting plate CAUTION: Ensure the power is off at the main fuse box prior to beginning installation . □ Turn off the switch at the wall. □ Turn the power off at the main fuse box. □ Attach the mounting plate (BB) to the outlet box using the outlet box screws (CC). (Important note: make sure one of the mounting hole in the mounting plate is facing right.) 2.
Installation instructions (continued) 3. Hanging the fixture body □ Raise fixture body (D) to the wall and carefully tuck the wires inside the outlet box. spread the electrical splices so that the black wires are on one side of the outlet box and the white wires are on the other side. line up the holes in backplate with holes in mounting plate and secure with two small screws (DD). Backplate D Hole Hole DD 4.
Installation instructions (continued) 5. Sealing the mounting surface □ Apply silicon or RTV compound between the edges of backplate and wall. Backplate 6. Installing the bulb □ Prior to installing the bulb, please inspect socket for silica packet, if packet is present, remove and throw away, do not expose to children and pets. □ Install the 120V, 60Hz, 60-Watt antique bulb (A) (included) or one 120V, 60Hz, 60-Watt max., medium-base type A bulb (not included) into the socket of the light fixture.
Installation instructions (continued) Care and Cleaning □ Clean the light fixture with a soft, dry cloth. Do not use any cleaners with chemicals, solvents, or harsh abrasives. Troubleshooting Problem Possible Cause Solution The bulb will not light. □ The bulb is burned out. □ Replace the light bulb. □ The power is off. □ Ensure that the power supply is turned on. □ There is a faulty wire connection. □ Check the wiring. □ The circuit breaker is off.
SINCE 1886 R
