User's Manual

6
CONNECTING TO THE CONTROLLER
Installing and Wiring the Module
Begin by activating the CR2032 backup battery (used for date/
time backup in the event of a power outage) by pulling the battery
insulator at the bottom of the module. The expected battery
life is ten years. If the battery requires replacement, the battery
compartment is located on the back of the Solar Sync module.
Remove the cover and install the battery with the positive side (+)
of the battery visible, facing toward you. Replace the battery cover.
Replace battery with CR2032 type battery only. Use of another
battery may present a risk of fire or explosion.
Note: Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
The Solar Sync module
is designed to be
wall-mounted next to the
irrigation controller. A
rubber cover is provided
for outdoor installations
to protect the module
from the weather. Use two
anchors or self-tapping
screws to secure the
module to the wall.
Place the rubber cover
mounting tab behind the
module before screwing
the module to the wall.
Note: If you are installing Solar Sync on an ACC or
X-Core Controller, the Solar Sync Module is not required.
For the ACC or X-Core controllers, the WSSSEN kit should
be used, as it does not include the Module. (See the
controller‘s owner‘s manual for more details.)