User's Manual

ADDRESSING WIRELESS RECEIVER/SENSOR

The Wireless Solar Sync Receiver

and Sensor are already paired with

the same frequency for an easy

installation. When installed, the

wireless Receiver will automatically

go into a “search” mode looking

for the signal from its paired Sensor.

However, it is a good idea to initialize

communication manually between

the wireless Receiver and Sensor

during installation to verify correct

signal transmission.

To initialize communication manually between wireless Receiver

and Sensor:

• After Receiver’s green and black wires have been connected

(see “Connecting To The Controller” section), restore power

to the controller

• The red LED in the center of the wireless Receiver will turn

on and stay solid for 10 seconds, indicating that it is in search

mode, searching for a signal from a wireless sensor

• While the red LED is solid and the wireless Receiver is in search

mode, press and hold the spindle on the wireless Sensor. The

LED on the wireless Receiver will blink 4 times and then turn

off, indicating that the signal from the wireless Sensor has

been acknowledged.

To Validate Receiver/Sensor Communication or Re-address:

• Press and hold the spindle on the wireless Sensor

• The LED on the wireless Receiver will blink 2 times, conﬁrming

that the Receiver is addressed to the Sensor properly

Note: In the event of a power outage (or any other

reason when the Receiver loses radio contact with

the wireless Sensor) the Receiver will automatically

go into search mode to re-establish communication

with the Sensor once power is restored. However,

when power is restored the controller will automati-

cally go into rain shut off mode until communication

with the Sensor is re-established, which may be up

to 60 minutes (maximum). Performing the steps listed

above to validate Receiver/Sensor communication will

remove the controller from rain shut off mode and

will return to its programmed irrigation schedule.

LED

spindle