User's Manual

12
CONNECTING TO THE CONTROLLER
X-Core Controller
The X-Core Controller is programmed with Solar Sync technology and, therefore,
does not require the use of the Solar Sync module. Simply mount the Wireless
Receiver on the controller cabinet using an available knock out and secure with the
supplied conduit nut. Or, use the supplied brackets to mount the Wireless Receiver
on the wall, similar to the Pro-C installation shown on page 8. Depending on the
installation, the supplied 1.5" (3.8 cm) extender may be required. Route the wires
from the Wireless Receiver in to the controller cabinet.
1. Make sure power to the controller is turned off
2. Connect the black Receiver wire to the “SEN” Terminal location (it does not
matter which “SEN” terminal is used)
3. Connect the green Receiver wire to the other “SEN” terminal location
See X-Core owner’s manual for further details.*
ACC Controller
The ACC Controller is programmed with Solar Sync technology and, therefore, does not
require the use of the Solar Sync module. Simply mount the Wireless Receiver on the
controller cabinet using an available knock out and secure with the supplied conduit nut.
Or, use the supplied brackets to mount the Wireless Receiver on the wall, similar to the
Pro-C installation shown on page 8. Depending on the installation, the supplied 1.5"
(3.8 cm) extender may be required. Route the wires from the Wireless Receiver in to the
controller cabinet.
1. Make sure power to the controller is turned off
2. Connect the black Receiver wire to the black “ET” terminal on the master module
3. Connect the green Receiver wire to the green “ET” terminal on the master module
See ACC owner’s manual for further details.*
Note: *The X-Core and ACC controllers have the Solar Sync software built in.
Please see the controllers’ owner’s manuals for Solar Sync programming instructions.