User's Manual

CONNECTING TO THE CONTROLLER

ICC Controller

1. Connect the

red

wire from the Solar Sync module to the AC1 terminal

2. Connect the

white

wire from the Solar Sync module to the AC2 terminal

3. Connect the

blue

wire from the Solar Sync module to the REM terminal

Remove

the ﬂat metal jumper from the two SEN terminals

5. Connect the

yellow

wire to one of the SEN terminals

6. Connect the

orange

wire to the other SEN terminal

Mount the Wireless Receiver on the controller cabinet using an available knock out and secure with the supplied conduit nut, similar to the

Pro-C installation shown on page 8. Or, use the supplied brackets to mount the Wireless Receiver on the wall. Depending on the installation,

the supplied 1.5" (3.8 cm) extender may be required. Route the wires from the Wireless Receiver in to the controller cabinet.

1. Make sure power to the controller is turned off

2. Connect the

black

Receiver wire to the black Module wire

3. Connect the

green

Receiver wire to the green Module wire

4. Initialize communication by following steps outlined in “Addressing Wireless Receiver/Sensor” section on page 13

Blue

Orange

Yellow

White

Red