User's Manual

CONNECTING TO THE CONTROLLER

Pro-C Controller (PC Series)

For the PC series Pro-C Modular controller, mount the Solar Sync module on the

wall next to the controller cabinet. There is an additional knockout on the right side

of the controller cabinet to route Solar Sync wires into and out of the cabinet.

1. Connect the

red

wire from the Solar Sync module to the AC1 terminal

2. Connect the

white

wire from the Solar Sync module to the AC2 terminal

3. Connect the

blue

wire from the Solar Sync module to the REM terminal

Remove

the ﬂat metal jumper from the two SEN terminals

5. Connect the

yellow

wire to one of the SEN terminals

6. Connect the

orange

wire to the other SEN terminal

Mount the Wireless Receiver on the controller cabinet using the options described on page 8. Due to the position of the power module in

the Pro-C controller, a more convenient option may be to mount the Wireless Receiver to the wall using the Wall Mount Bracket.

1. Make sure power to the controller is turned off

2. Connect the

black

Receiver wire to the black Module wire

3. Connect the

green

Receiver wire to the green Module wire

4. Initialize communication by following steps outlined in “Addressing Wireless Receiver/Sensor” section on page 13