User's Manual

Pro-C Conventional Controller (PCC Series)

Mount the Wireless Receiver on the controller cabinet using an available knock out and secure with the supplied conduit nut. Or, use the

supplied brackets to mount the Wireless Receiver on the wall. Depending on the installation, the supplied 1.5" (3.8 cm) extender may be

required (shown below). Route the wires from the Wireless Receiver into the controller cabinet.

1. Make sure power to the controller is turned off

2. Connect the

black

Receiver wire to the black Module wire

3. Connect the

green

Receiver wire to the green Module wire

4. Initialize communication by following steps outlined in “Addressing Wireless Receiver/Sensor” section on page 13

CONNECTING TO THE CONTROLLER

P C C S E R I E S

SEN: ORANGE

SEN: YELLOW

REM: BLUE

Controller Connections

AC2: WHITE

AC1: RED

1.5" extender

(optional use)

Green

Black

Wireless Receiver

Mounted to Controller

Wall Mount Option