User's Manual

9

CableandLeadConnections
RedandBlueLeads:Connectthestraightconnectorsbypushingallthe
wayintotheappropriatelycoloredplugs.
ProgrammingCable:Connecteitherendofthesuppliedcabletothe
connectorontheICD‐HP.Alignconnectorslotswithfemaleconnectoron
programmer,pushstraight
in,andturn90degreesuntiltheconnector
locksintoplace.
ConnecttheotherendoftheProgrammingCabletotheProgramming
Cupinthesameway.
ConnectingtoaDecoder
TheICD‐HPprogrammerworkswithHunterICDandlaterdecoders.The
ICD‐HPprogrammingcupcommunicateswithdecodersthrough
wirelessinduction.
Thebottomendofthedecoder(oppositetheendwiththewires)isthereceiverareaforthesignalsfromthe
programmingcup.
Theentireinsideofthecupiswithinthewirelessrange,
anditisnotnecessarytopressdecodersfirmlyinplace,as
longastheyarewithinthecup.Theprogrammingcup
Blue
Lead
Red
Lead
Programming
Cable