User's Manual

24

IftheversioninthedecoderisolderthantheversionloadedintotheICD‐HP,
andyouwishtoupdatethedecoder,pressNext3.Thiswillshowtheversion
ofthe“bootloader”program,whichactuallyloadsthefirmwareintothe
decoder.
PressNext3againtocontinue,
andthefirmwareupdatewillbegin.Astatus
barwillshowtheprogressofthedownload.
Itwilltakeseveralminutestoupdateadecoder’sfirmware.Donotdisconnectthedecoderduringthisupdate!The
firmwareupdateshouldalwaysbeallowedtocomplete,onceithasbegun.
Theupdatewill
noterasethedecoderoutputstationaddresses.IfthedecoderisusedasaPump,thisinformationwill
alsoberetained.
IfthedecoderisaSensorDecoder,itwillautomaticallyreceivetheSensor
Decoderfirmware,andtheaddressandportsettingswillberetained.
Astatusscreenwillannounce
whentheupdateiscomplete,andverifythe
newversionnumber.


DECODER UPDATE
----------------------
Update Progress...

DECODER UPDATE
----------------------
!Complete!
Dec Type: X-Station
Station #: ###
Serial #: ########
Version: #.##.###