User's Manual

19

Donotassignduplicateaddresses!Nodecodercontrollershouldhaveduplicatestationnumbers,anywherewithinthe
entiresystem.(Thisdoesnotapplytostation000,however.)
TheICD‐HPwillnotallowduplicatestationnumberswithinasingledecoder,butitcannotdetectduplicateselsewherein
thesystem.
Sensor
DecoderProgramming(ICD‐SEN)
IfthedecoderintheprogrammingcupisanICD‐SENsensordecoder,only
theaddresscanbeset.TheTypewillbeSensor,andthiscannotbe
changedwhenasensordecoderisfound.
Chooseanaddressbetween1‐5withthe+or–buttons,
andpressNext3
tosendtothesensordecoder.
TurnLinePowerOff,andBackOn:Afterprogrammingorre‐programming
installeddecoders,thetwo‐wirepathpowermustbeturnedofffor15seconds,andthenbackon,fortheprogramming
totakeeffectinthefield.
Other
SensorDecodersetupoptionsaremadeatthecontroller,andnotfromtheICD‐HP.Consultcontrollerand/or
sensordecoderdocumentationforcompletesetupinstructions.
GetDecoderStatus
PROGRAM A DECODE
R
----------------------
 Dec Type: Sensor
Address: 0