User's Manual

11

Seattheprogrammingcupoverthedecoder.Thebottomofthedecoder(theendwithnowires)shouldbe
withintheprogrammingcup.
Verifythatthetwo‐wirepathisconnectedtothecontroller,andthatcontrollerpowerison.
Thedecoderwillbepoweredoverthetwo‐wire
path,andtheredandblueICD‐HPleadswillnotbenecessary.
ProtecttheICD‐HPfromsprinklersprayandotherwatersources!
Operations
Turntheprogrammeronwiththepowerbutton.Thelogowillappear,andchangetotheMainMenuinafewseconds.
MainMenu&Navigation
Forthefirstuse,ortochangegeneralsettings,selectICD‐HPSetup.
MostmenuselectionsthroughoutICD‐HPoperatewiththesamebuttons.Usethearrowkeystonavigatearoundthe
screens.Usethe+and–buttonstochangethechoicesinsettings.UsetheNext3buttonto
selectanoption,andgoto
thenextscreen.UsetheBack4buttontoexitandreturntothepreviouslevel.
Insomeselections,theEnterbutton
 isusedtomakeselections.