Owner Manual

ManualsBrandsHunter Fan ManualsAll Ceiling Fans52'' Kenbridge 5 - Blade Standard Ceiling Fan with Pull Chain and Light Kit Included

www.HunterFan.com

1.888.830.1326

Troubleshooting

Excessive wobbling

• Tighten all of the blade and

blade iron screws until they

are snug.

• Turn the power off, support

the fan carefully, and check

that the hanger ball is

properly seated.

• Use the provided balancing

kit and instructions to balance

the fan.

Noisy Operation

• Tighten the blade and blade

iron screws until they are snug.

• Check to see if any of the

blades are cracked. If so, replace

all of the blades.

Fan doesn’t work

• Make sure power switch is on.

• Pull the pull chain to make sure

it is on.

• Push the motor reversing switch

rmly left or right to ensure that

it is engaged.

• Check the circuit breaker to

ensure the power is turned on.

• Make sure the blades spin freely.

• Turn off power from the circuit

breaker, then loosen the canopy

and check all the connections

according to the wiring diagram

on page 10-11.

• Check the plug connection in

the switch housing.

To uninstall the light kit

• First carefully remove the globe and bulbs. Detach

the lower switch housing from the upper switch

housing. In the lower switch housing, disconnect the

black wire from the blue wire and disconnect the

two white wires.

• Remove the reverse switch by unscrewing the two

screws on the outside of the lower switch housing.

• Remove the fan switch by unscrewing the switch nut

located under the light kit shroud.

• Install the fan switch assembly into the optional

lower switch housing by feeding the pull chain

through the round hole in the side of the optional

switch housing. Secure the switch by installing the

switch nut to the threaded barrel on the outside

of the switch housing. Hand tighten the nut in a

clockwise direction until snug.

• Install the reverse switch into the optional lower

switch housing by aligning the reverse switch with

the square hole in the side of the optional switch

housing then installing the two screws.

• Once both switches have been installed in the

optional switch housing, install the dummy terminals

(included in the sack parts) on the two disconnected

wires in the lower switch housing.

• Repeat the steps on page 15 to install the lower

switch housing.