Owner Manual

8
9
1886
1886
After rotating the light
xture into place, tighten
all three screws securely.
Installing the Bulbs and Glass
ON
Turn Power
Ceiling Bracket Downrod Hanging Fan Wiring Canopy Blades Light Bulbs/Glass Remote CradleRemote
Lift the light xture so that the larger keyhole
slots slide over the screws. Rotate the light
xture counterclockwise. Ensure all three
screws are engaged in the keyhole slots.
Install the included LED
bulbs into the sockets.
When necessary, replace
with bulbs of same wattage.
Lift the globe and align the
notches in the globe with
the tabs in the light kit.
NOTE: Check to ensure
proper engagement.
Attach the globe by lifting and
turning clockwise one quarter of a
full turn of the glass until it stops.
Blade Arm Screw
Replacement bulbs may be available on www.costco.com.
Hunter Pro Tip:
Assembling the Trim Ring
Assembling the Light Fixture
Notch
Screw
Screw
Screw
Tab
After rotating the
trim ring into place,
tighten all three
screws securely.
Screw
Screw
Screw
Connect the plugs from
the fan and light xture.
Make sure to line up
the colored markings
on the connectors.
Lift the trim ring so that the
larger keyhole slots slide
over the screws. Make
sure the plug connector is
pushed through the central
hole in the trim ring.
Rotate the light xture
counterclockwise. Ensure all
three screws are engaged
in the keyhole slots.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the trim ring to the mounting plate.
WARNING
FAN FALL HAZARD
Make sure all three screws are tight to secure
the light xture to the trim ring.
WARNING
GLASS FALL HAZARD
To prevent SERIOUS INJURY or DEATH, make
sure that glass is properly secured.