. {, N SINCE LEES UNIVERSAL FAN-LIGHT CONTROL INSTALLATION INSTRUCTIONS—MODEL 22798 FOR THREE FAN SPEED AND SIX LIGHT LEVEL CONTROL . RF REMOTE CONTROL (FOR HORIZONTAL MOUNT ONLY, NOT FOR USE WITH FLUSH MOUNT FANS EXCEPT HUNTER MODELS) READ AND SAVE THESE INSTRUCTIONS CAUTION: This device complies with pray: 13of the FCC: rules: Changes or modifications not expressly approved by Hunter Fan Company could void your authority 1o operate.
ELECTRIC CABLE 5205 ) X sane neoprene v GROUND WIRE CONTROL & FIGURES 4, (Continued) Push the wires up ins-the outlet box and (e wire connectors 1o point upward. Separate the wires 56 that the Black wires are on one side of the box and the white wires ate on the other 5. Bring the control up 10 the ceiling, Feed the bear capped ground wire down through the center hole of the control, Use Yhe fan mounting brackets {o hold the control and the fan mounting hanger in pace, See Figure 4.
; SETTING OF PULL CHAIN SWITCH ‘Nexis step is 10 sul the pull chain switch to high position, This is recurred to obtain correct high-med-low speeds by remote ton L Fess fan bunion of the tans miner once. Fan should run al high sped. If not; sam the main switch off. Pull the chain once 1o next potion and turn on the power. NOTE: Neva pull the chain when power is on-after-installing the control. 2 Press fan button of transience again, if the fan speed is not set er high.
