Brochure

20-2169-1 – Adds 40".
20-2189-1 – Adds 50".
Approach Ramp Extensions Conventional Sensor Extension
Drive-Thru Kit
For surface-mount, drive-thru
application. Use standard kit for
camera sensors and extended
kit for conventional sensors.
20-2498-1 – Standard kit for camera
sensors. Adds 53" in length.
20-2501-1 – Extended kit for
conventional sensors. Adds 61"
in length.
20-2498-1 – Standard kit for camera
Provides additional space at the
front of runways. Required when
using conventional sensors with
toe arms.
20-2497-1 – Adds approximately
12" in length.
20-2497-1 – Adds approximately
Extensions lessen the ramp incline
for high-floor-slope installs and
ease service for specialty vehicles.
147-104-1 – Adds
13" (2 required).
147-113-1 – Adds
18" (2 required).
147-104-1 – Adds
20-2169-1 – Adds 40".
OPTIONAL
OPTIONAL
OPTIONAL
Swing Air Jacks
Hunter Swing Air Jacks add capabilities
for lifting vehicles off the runways during alignment
procedures and other multi-service operations.
Each 9,000-lb. (4,082 kg) capacity Swing Air Jack
combines low drive-on height with high lifting capacity
needed to handle a wide range of vehicles.
133-83-1 – 9,000-lb. Capacity Swing Air Jack
AlignLights System
Hunter’s integrated AlignLights lighting system provides
an efficient light source underneath the vehicle.
AlignLights automatically turns on when the lift is
raised and turns off when the lift is lowered to the floor.
AlignLights is an ALI-listed accessory.
20-2173-1 – AlignLights system
OPTIONAL