RX16 Scissor Lift Low, Long, Fast and Strong NEW!
RX16 Scissor Lift Best-In-Class Drive-On Height 9" 6 7 8 9 10 11 12 Massive capacity with a small footprint ✔ Only 9" fully lowered*** ✔ No clearance problems 1 2 3 4 5 Extra-Wide Runways Two Swing Ai 26" ✔ 26" runways accept wide, heavy vehicles Sensor Feedback System* ✔ Sensors keep runways level ✔ Safely stops if obstructed ** Velocity Safety Fuses Safety Locks Power-Up System ✔ Instantaneous shutdown in event of hydraulic failure ✔ Precision-fit teeth lock runways at 15 level
Two Movable Work Steps ir Jacks Louvered Ramps ✔ 9,000-lb. capacity ✔ 13 secure positions ✔ Technicians’ favorite ✔ Lightweight design ✔ Prevent wheel spin in wet conditions ✔ More effective than diamond tread or abrasive strips Control Panel ✔ Complete operation from the console RX16T-IS shown with optional light kit ✔ Optional PowerSlide, Inflation Station and FIA control Raise Height Inflation Station (optional) 76" ✔ Power-Up engages to lift heavy vehicles (up to 16,000 lbs.
Fast Descent Speed The hydraulic system speeds lowering times by 50%. The system automatically slows the descent in the last several inches to ensure a soft landing. 0:25 FAST Descent Power-Up System Hunter’s dual-capacity lifting system offers the ground-clearance advantages of a standardcapacity lift to handle most vehicles. To service heavy vehicles, the exclusive Power-Up feature boosts lifting capacity to a massive 16,000 lbs.
Swing Air Jacks Hunter Swing Air Jacks add capabilities for lifting vehicles off the runways during alignment procedures and other multi-service operations. Each 9,000-lb. (4,082 kg) capacity Swing Air Jack combines low drive-on height with high lifting capacity needed to handle a wide range of vehicles. 133-83-1 – 9,000-lb. Capacity Swing Air Jack AlignLights System OPTIONAL Hunter’s integrated AlignLights lighting system provides an efficient light source underneath the vehicle.
Hunter Offers Two Fully Integrated Options to Enhance Productivity FIA allows WinAlign® aligners to control lift features for ultimate productivity. Two patented designs offer greater flexibility and timesaving capabilities. Shown with optional aligner console, sensors, bar code reader, target support brackets, and lights.
P O W E R S L I D E E D I T I O N ✔ Locks slipplates and turnplates with the touch of a button or automatically through an FIA-equipped aligner** ✔ No more struggles with lock pins ✔ Avoid wear and tear and extend the life of your turnplates Yesterday's Technology Minimize trips around the car 1 Mount Targets 2 Make Adjustments Only 3 Trips! 1 3 Remove Targets 8 Trips 4 Jack Vehicle and Compensate Sensors 5 Lower Leveling Legs (if equipped) 2 3 6 Remove Slipplate and Turnplate Pins 7 Replace Slip
RX16 Specifications Max. vehicle weight: Max. lifting height: 16,000-lb. mode Standard-capacity mode Flush-mount version Alignment height: Lifting speed: Lowering speed: 16,000 lbs. (7257 kg) 68" (1727 mm) 76" (1930 mm) 72" (1829 mm) All lock positions 60 seconds 25 seconds Tread width: Min. inside Max. outside Max. wheelbase: General service Two-wheel alignment Four-wheel alignment Min.
