Specification Sheet

SPECIFICATIONS
RX12AJT, RX12AT-PS & RX12AT-IS
Surface Mount Lift Rack
Site Specications
Power Requirements 208-230 VAC, single phase power, 26 Amp
Air Supply Requirements 90-150 PSI (6.2-10.3 bar)
Minimum Concrete Spec. 3 in. (76 mm) thick, 3000 PSI (20,700 kPA) rating
Maximum Floor Slope 2 in. (51 mm) over 126 in. (3200 mm)
Product Specications
Max Vehicle Weight 12,000 lbs. (5443 kg)
Max Wheelbase
General Service 184 in. (4673 mm)
Two-Wheel Alignment 179 in. (4547 mm)
Four-Wheel Alignment 158 in. (4013 mm)
Alignment Height All lock positions
Min. Four-Wheel Alignment 88 in. (2235 mm)
Lifting Speed 55 sec.
Lowering Speed 50 sec. / 25 sec. for 2-speed (T-IS)
RX12AT-IS Shown
Form 6498-T, 12-12
Supersedes Form 6498-T, 04-12b
Copyright © 2012, Hunter Engineering Company
L
For lift rack information visit:
www.hunter.com/rack
For local contact visit:
www.hunter.com/company/ndrep.cfm
For general inquiries visit:
www.hunter.com
or call
800-448-6848
MODEL FEATURES / DIMENSIONS / OPTIONS
Feature
JT T-PS T-IS
6000-lb Swing Air
Jacks (2)
Two-Speed
Lowering
H2
Dimension
Length (L)
266 in. (6766 mm)
Outside Width (W1)
88.5 in. (2248 mm)
Inside Width (W2)
40 in. (1016 mm)
Runway Width (R)
24 in. (610 mm)
Raised Height (H1)
71 in. (1803 mm)
Stack Height (H2)
10 in. (254 mm)
Continued on Page 2
W1
H1
Options Add Length
Kit #
Extended Approach
Ramp Ext. (Back)
5 in.
127 mm
147-113-1
2 required
Approach Ramp Ext.
(Back)
27 in.
686 mm
20-2169-1
Approach Ramp Ext.
(Back)
37 in.
940 mm
20-2189-1
Conventional Sensor
Ext. (Front)
12 in.
305 mm
20-2497-1
Drive-Thru Kit
(Front)
53 in.
1346 mm
20-2498-1
Extended Drive-Thru
Kit (Front)
61 in.
1549 mm
20-2501-1
RW2