Specification Sheet

SPECIFICATIONS
RX12AJFT & RX12AFT-PS
Flush Mount Lift Rack
Site Specications
Substructure Requirements Refer to 6469-T for full details
Power Requirements 208-230 VAC, single phase power, 26 Amp
Air Supply Requirements
90-150 PSI (6.2-10.3 bar)
Jacks require 125 PSI (8.6 bar) for full capacity
Minimum Concrete Spec. 3 in. (76 mm) thick, 3000 PSI (20,700 kPA) rating
Maximum Floor Slope 2 in. (51 mm) over 126 in. (3200 mm)
Product Specications
Max. Vehicle Weight 12,000 lbs. (5443 kg)
Max. Wheelbase
General Service 180 in. (4572 mm)
Two-Wheel Alignment 175 in. (4445 mm)
Four-Wheel Alignment 158 in. (4013 mm)
Alignment Height All lock positions
Min. Four-Wheel Alignment 88 in. (2235 mm)
Lifting Speed 55 seconds
Lowering Speed 50 seconds
Form 6499-T, 06-15
Supersedes Form 6499-T, 12-12a
Copyright © 2015, Hunter Engineering Company
For lift rack information visit:
www.hunter.com/lift-racks
For local contact visit:
www.hunter.com/contact-hunter
For general inquiries visit:
www.hunter.com
or call
800-448-6848
MODEL FEATURES / DIMENSIONS
Feature
JFT FT-PS
6000-lb Swing Air
Jacks (2)
Two-Speed Lifting
Continued on Page 2
RX12AFT-PS Shown
W1
H1
H2
L
Dimension
Outside Width (W1)
88.5 in.
2248 mm
Inside Width (W2)
40 in.
1016 mm
Length (L)
228.375 in
5801 mm
Runway Width (R)
24 in.
610 mm
Raised Height (H1)
71 in.
1803 mm
Depth (H2)
10.5 to 11.5 in.
267 mm to 292 mm
W2 R