Specification Sheet

SPECIFICATIONS
RX10 & RX10L (JT, T-PS & T-IS)
Surface Mount Lift Rack
Form 6493-T, 12-12
Supersedes Form 6493-T, 04-12b
Copyright © 2012, Hunter Engineering Company
*Non-standard positioning of control console is limited to a maximum space between console and rack of 6 feet
(1829 mm) at the approach ramp end and 18 feet (5486 mm) at the turnplate end. Additional threshold and perhaps
hydraulic hoses will be required (refer to Installation Instruction for details).
16
(406 mm)
IN.
4 (101 mm) RECOMMENDED MIN.IN.
22
(559 mm)
IN.
24 IN.
(610 mm)
LEAVE AMPLE WORKSPACE BETWEEN
EQUIPMENT AND LIFT RACK
ALIGNMENT EQUIPMENT
7 FT. - 4 1/2 IN.
(2248 mm)
FOR RX10JT
20 FT. - 1 1/4
(6128 mm)
LIFT
LENGTH
FOR RX10LJT,
RX10LT-PS
RX10LT-IS
21 FT. - 2 1/4
(6458 mm)
LIFT
LENGTH
,
RX10T-PS AND
RX10T-IS
IN.
AND
IN.
39 - 54
(991 - 1372 mm)
IN.
PRIOR TO LIFT INSTALLATION:
INSTALL 230VAC, 1 PHASE,
60 HZ FOR 26 AMP DRAW NEAR
CONTROL CONSOLE LOCATION.
90-150 PSI (6.2-10.3 BAR) SHOP
AIR MUST ALSO BE SUPPLIED.
13’ (3962 mm)
RECOMMENDED
BAY WIDTH
16
(406 mm)
IN.
11 5/8 IN.
(295 mm)
OPTIONAL
EXTENDED
WHEEL STOP