Specification Sheet

ManualsBrandsHunter Engineering ManualsLift RacksHunter Engineering RX10 / RX17 Scissor

SPECIFICATIONS (Refer to 6198-T for substructure construction requirements)

RX10FT-IS

Flush Mount Lift Rack

Form 6495-T, 06-15

Supersedes Form 6495-T, 12-12a

Dimensions shown are for nished pit. Tile thickness (if applicable) must be considered before pouring pit.

*Non-standard positioning of control console is limited to a maximum space between console and rack of 6 feet

(1829 mm) at the approach ramp end and 18 feet (5486 mm) at the turnplate end. Additional threshold and perhaps

hydraulic hoses will be required (refer to Installation Instruction for details).

WARNING

DRAIN

LOCATED

CENTER

OF PIT

SLOPE

PIT

FLOOR

TOWARD

DRAIN

(1/2")

CONSOLE CONDUIT DETAIL

92 1/2"

(2350 mm)

WARNING

STAY BEHIND

YELLOW LINE

WHEN THE

LIFT MOVES.

128-978-2

DECAL 128-978-2

OPTIONAL CONSOLE LOCATION

(4 places on edging and 2 places on lift)

41 3/8"

(1051 mm)

141 3/4"

(3600 mm)

14"

(356 mm)

APPROX. 2" (51 mm) TYPICAL

14"

(356 mm)

(127 mm)

14" X 5"

CUTOUT

(4 places)

ANGLE AROUND PIT PERIMETER:

- not around

- painted safety yellow

- not supplied by Hunter

14" X 5" cutouts

16"

(406

mm)

22"

(559 mm)

6" MIN.*

152 mm()

OPTIONAL 1 1/2" DIA. CONDUIT

FOR COMMUNICATION CABLE

TO ALIGNMENT CONSOLE

HAWKEYE SERIES SENSORS

AND PRONTO SYSTEMS HAVE

SPACE REQUIREMENTS IN

FRONT OF LIFT THAT MUST BE

MET, REFER TO APPROPRIATE

SITE REQUIREMENTS.

ENTIRE PIT

(BOTTOM AND WALLS)

MUST BE HARD

TROWEL FINISH

FILLER PLATE

51-2308-1

(4 places)

placed over

14" X 5"

cutout

215 3/8"

(5471 mm)

34 3/4"

(883 mm)

60 1/4"

(1530 mm)

24 1/4"

(616 mm)

EXTENDER

PLATES

51-2464-1-PPP

AND

RAMPS

147-141-1-PPP

RAMPS

147-141-1-PPP

VEHICLE APPROACH

* LONGER VEHICLES WILL NEED TO BE SERVICED WITH BAY DOOR OPEN. TO

ACCOMMODATE MOST VEHICLES, INCREASE SPACE BEHIND PIT TO () OR

GREATER.

39" 991 mm

** SITES WITH D.R.W. TRUCK

TRAFFIC SHOULD USE 20" MIN.

CONSOLE TO PIT DISTANCE.

15" TO 41"

(381 TO 1041 mm)

6" MIN.

RADIUS

CONDUIT

EXIT FLUSH

WITH

PIT FLOOR

ROUTE 4" MIN DIAMETER

CONDUIT OR EQUIVALENT

CLOSED CHANNEL FROM

PIT FLOOR TO BASE OF

CONSOLE

BAY DOOR