Specification Sheet

SPECIFICATIONS
RX10FT-IS
Flush Mount Lift Rack
Site Specications
Substructure Requirements
Refer to 6198-T for full details
Power Requirements
208-230 VAC, single phase power, 26 Amp
Air Supply Requirements
90-150 PSI (6.2-10.3 bar)
Jacks require 125 PSI (8.6 bar) for full capacity
Minimum Concrete Spec. 3 in. (76 mm) thick, 3000 PSI (20,700 kPA) rating
Maximum Floor Slope 2 in. (51 mm) over 126 in. (3200 mm)
Product Specications
Max. Vehicle Weight 10,000 lbs. (4536 kg)
Max. Wheelbase
General Service 167 in. (4241 mm)
Two-Wheel Alignment 162 in. (4115 mm)
Four-Wheel Alignment 158 in. (4013 mm)
Alignment Height All lock positions
Min. Four-Wheel Alignment 88 in. (2235 mm)
Lifting Speed 55 seconds
Lowering Speed 25 seconds
Form 6495-T, 06-15
Supersedes Form 6495-T, 12-12a
Copyright © 2015, Hunter Engineering Company
For lift rack information visit:
www.hunter.com/lift-racks
For local contact visit:
www.hunter.com/contact-hunter
For general inquiries visit:
www.hunter.com
or call
800-448-6848
MODEL FEATURES / DIMENSIONS
Feature
FT-IS
6000-lb Swing Air
Jacks (2)
Two-Speed Lowering
Continued on Page 2
RX10FT-IS Shown
W1
H1
H2
L
Dimension
Outside Width (W1)
88.5 in.
2248 mm
Inside Width (W2)
40 in.
1016 mm
Length (L)
215.375 in.
5471 mm
Runway Width (R)
24 in.
610 mm
Raised Height (H1)
72 in.
1829 mm
Depth (H2)
9.25 to 10.25 in.
235 mm to 260 mm
W2 R