Brochure

Swing Air Jacks
Hunter Swing Air Jacks add capabilities for
lifting vehicles off the runways during alignment
procedures and other multi-service operations.
The heavy-duty Swing Air Jack has a capacity of
9,000 lbs. (4,082 kg) and combines low drive-on
height with high lifting capacity needed to handle
a wide range of vehicles.
133-84-1 – 9,000-lb. Capacity Swing Air Jack
AlignLights System
Hunter’s AlignLights lighting system provides an
efficient light source underneath the vehicle.
AlignLights is powered by the main lift power source
and requires no additional or exposed electrical cords.
AlignLights automatically turns off when the lift is
lowered to the floor and turns on when the lift is raised.
AlignLights is an ALI listed accessory.
20-2993-1 – AlignLights system for four-post lifts
OPTIONAL
Turnplates
20-2076-1 PowerSlide Turnplates with Automatic Bridges
Two stainless steel turnplates for camera-sensor systems.
20-2075-1 PowerSlide Turnplates without Automatic Bridges
Two stainless steel turnplates for conventional-sensor systems.
20-2532-1 Stainless Steel Turnplate Kit
Two stainless steel Delrin-ball turnplates and bolt-on guide strips.
20-2533-1 Low-Friction Stainless Steel Turnplate Kit
Two stainless steel Torlon ball turnplates and bolt-on guide strips.
20-2531-1 Powder-Coated Turnplate Kit
Two powder-coated, Delrin-ball turnplates and bolt-on guide strips.
Integrated bridge lowers and raises as plates
are locked, making rolling compensation a
snap. Air-operated control system ties directly
into PowerSlide lifts (20-2076-1 shown).
All L451T and L454T models will ship with the most appropriate turnplates.
When making a substitution, any of the following turnplates may be used.
Integrated bridge lowers and raises as plates
Integrated bridge lowers and raises as plates
Integrated bridge lowers and raises as plates
When making a substitution, any of the following turnplates may be used.