User's Manual

•

Mounting Sensors DSP700 Series Wireless Wheel Alignment Sensors

CAUTION: When mounting sensors to the wheel adaptors, the sensor shaft

must be fully seated. Make certain that there is no play or

looseness between the sensor shaft and the wheel adaptor.

Rotate the wheel while holding the sensor. Listen and feel for

movement between the sensor and wheel adaptor. Runout

compensation and alignment accuracy will be adversely affected

if there is any movement between the sensor and wheel adaptor.

Sensors must fit tightly against the surface of the wheel adaptor

or the lock may not hold. This could allow the sensor to fall and

be damaged.

2.2 Mounting Wheel Adaptors onto Wheels

Typical Installation (Grasping the Outside of Rim Lip)

NOTE: Rim studs are reversible. Use the spade end that best fits the

rim. The two wheel adaptors on the front wheels or back wheels

need to be uniform with same end of the rim studs engaged onto

the rim.

Position the wheel adaptor with the two upper external rim studs on the outside of the

wheel rim.

Align the two lower external rim studs on the outside of the wheel rim and check that all

four rim studs will engage the outside of the wheel rim.

Turn the adaptor adjustment knob clockwise to firmly attach the adaptor to the wheel.

RIM STUD

ADAPTOR

ADJUSTMENT

KNOB

Test the security of the installation by lightly tugging on the wheel adaptor.

CAUTION: Do not allow the rim studs to slip on the wheel. Runout

compensation and alignment accuracy will be adversely affected

if the wheel adaptor is allowed to slip on the wheel.