Manualshelf

User's Manual

ManualsBrandsHunter Engineering ManualsElectronicsHunter Model 45-1549, XF Wireless Communication Network Radio
11121314151617181920
DSP700 Series Wireless Wheel Alignment Sensors Mounting Sensors
•
15
Operation of Ratchet Adaptor Locking Lever after Initial Setup
To remove the sensor, loosen the sensor shaft by turning the adaptor locking lever
counter-clockwise to the 3 o’clock position.
To loosen, turn the adaptor locking lever from 9 to 3 o’clock.
To lock, turn the adaptor locking lever from 3 to 9 o’clock
To lock the sensor shaft, tighten the sensor shaft by turning the adaptor locking lever
clockwise to 9 o’clock position.
CAUTION: Failure to follow tightening and loosening procedures may result
in damage to the adaptor locking lever. Upper casting can
damage adaptor locking lever if contact occurs when going from
a large to small diameter rim. Refer to figure below. Also refer to
“2.2 Mounting Wheel Adaptors onto Wheels” for information for
adjusting adaptor size.
LOWERING THE
UPPER CASTING
CAN DAMAGE
THE LEVER
WHEN LOCATED
IN THE WRONG
POSITION